If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Sorry 6666, nothing about programming AT MEGA and fuse setting.
From start it was provided for purchase PCB and preprogrammed micro.
Otherwise it should be business as usual with programming AT MEGA 8.
WM6, do you see any information about fuse bits value , thanks,
Sorry 6666, nothing about programming AT MEGA and fuse setting.
From start it was provided for purchase PCB and preprogrammed micro.
Otherwise it should be business as usual with programming AT MEGA 8.
It is classical micro PI. Comparable with Stuart PI. Dedicated to AT Mega micro lover.
There is a lot to play with front end (coil, damping R, ignition transistor, diodes, OpAmp ...) to get best results and possibly learn something new.
WM6, do you see any information about fuse bits value , thanks,
Do you thing it would be a good simple diy detector?
It is classical micro PI. Comparable with Stuart PI. Dedicated to AT Mega micro lover.
There is a lot to play with front end (coil, damping R, ignition transistor, diodes, OpAmp ...) to get best results and possibly learn something new.
Leave a comment: