Arduino based VDI!

[wesamal75]

On the admiral schematic, it looks like pin 1 and pin 7 of U4 (TL062).

There is no LF347 so I assume this chip if from the idx schematic.

Thank you , i connect to pin 1and7of tl 062 and when i conect groun of arduino to the ground of admiral always give id 93 when any thing goes in the coil the id chang and return back to 93 fastly and whith out connect groun of arduino to ground of admiral give 0 value whithout any chang of id

[dbanner]

On the admiral schematic, it looks like pin 1 and pin 7 of U4 (TL062).

There is no LF347 so I assume this chip if from the idx schematic.

[dbanner]

Ok, I'll have a look to see where the VDI is attached

[wesamal75]

Which admiral schematic? post the schematic.

I attached the schematic in the last post

[wesamal75]

This one i used

[wesamal75]

[dbanner]

Dear all
Im mad this vdi and connect to admiral metal detector put when i run device writ on the screen 93 dollar it musr nor writ any thing when start , i connect x,r to the ic 339 oin 2, 14
And try ic 347 pin 7,8 the same problems

Which admiral schematic? post the schematic.

[wesamal75]

Dear all
Im mad this vdi and connect to admiral metal detector put when i run device writ on the screen 93 dollar it musr nor writ any thing when start , i connect x,r to the ic 339 oin 2, 14
And try ic 347 pin 7,8 the same problems

[useus]

I don't understand, on idx pro, x and y must be connected to pins 1-14 or 7-8 of lf347?
I follow the scheme with mcp602 to build the vdi?


thanks!

[Hyena]

Unfortunatelly, its still too little information to use my magic crystal ball.

[andon80]

I can't load arduino hex with friends .it gives error .please help

[andon80]

I guess no one will help about Arduino VDI

[andon80]

help friends
it's been a long time, VDI. check all files
they all make mistakes
please send me a really running program
note: running when I throw another Arduino program
so there's no connection error
VDI generates compile error
please help

[samsearcher]

(Menu options I mean).... It would be nice to incorporate Dons' 'ID labels' instead of the ID numbers, I'll have a play

john

[samsearcher]

Bernte,
makes sense, thanks.

I'll test in the field and see how it goes.. When all looks good I'll create new thread with a more detailed instructions.
daren

Daren, did you finalise all this elsewhere?....mine is working (V13) but not quite sure what all the options are!
THANKS