i do not want to know what you change.
i asked you to measure the voltages.
you see yourself - NO POWER SUPPLY ON THE BOARD. ABSENT.
begin to fix the problem.
Announcement
Collapse
No announcement yet.
For sale bare boards for Delta Pulse/Sniffer XR-71
Collapse
X
-
desolder mosfet.
set tester probe in control point -E, another probe in GND and after in +E. write what you see.
tester range 20V, DC.
Leave a comment:
-
Surprised to learn remoteness an issue for expert.
All was working fine when i changed C3 from 15nf to 18nf and the tone changed and red LED blinked when DEPTH pot to near full.
Then I installed new block connectors.
I also touched up solder of R52.
Next i power the board but no green or red LED, no detection, no tone.
Next i replaced MOSFET, all IC, DA7, VD7,VD8,VD9 but no success.
Leave a comment:
-
Originally posted by chuubaba View Post
BTW which transistor drives MOSFET? I want to replace it.To try and diagnose a fault remotely is extremely difficult, especially when the person at the other end doesn't know what they're doing. Even with the best will in the world, you're chances of getting this working are very slim. Do you not have a friend nearby who can assist you?Originally posted by chuubaba View PostYes i saw his answer and i am waiting for his diagnosis.
As i said before your knowledge about electronics is equal to mine because you also can't figure out what is problem with this board.
Leave a comment:
-
Yes i saw his answer and i am waiting for his diagnosis.Originally posted by Qiaozhi View PostBeyond hope, I'm afraid.
Did you not see KT's answer below? There is no transistor.
As i said before your knowledge about electronics is equal to mine because you also can't figure out what is problem with this board.
Leave a comment:
-
Beyond hope, I'm afraid.Originally posted by chuubaba View Post
BTW which transistor drives MOSFET? I want to replace it.
Did you not see KT's answer below? There is no transistor.
Originally posted by kt315 View Postlongest rip away you send him seeking this transistor. DP mosfet is driving directly from/by NE556.
Leave a comment:
seek the problem. has to be 
Leave a comment: