BARACUDA STEP 6/7 ADJUSTING R14 TO -2.1V

[BKY1337]

Its also different in the Barracuda Legend.

[Qiaozhi]

Hey guys PLEASE HELP!!!!!!!!!!!!!! im stuck in step 6/7 adjusting R14 to -2.1V.... i have made sure the coil is connected and i have shorted pin 2 of PL2 to pin 1 or 3..
When i place the multimeter on pin 1 of U7 i get a positive reading but on the instructions it says adjust R14 to negitive -2.1V ?????? any suggestions...

As long as the DC voltage at pin1 of U7 changes when you place a metal object near the coil, then I wouldn't worry too much about the voltage of -2.1V. This can vary from one build to another.

[METALHEAD]

Hey guys PLEASE HELP!!!!!!!!!!!!!! im stuck in step 6/7 adjusting R14 to -2.1V.... i have made sure the coil is connected and i have shorted pin 2 of PL2 to pin 1 or 3..
When i place the multimeter on pin 1 of U7 i get a positive reading but on the instructions it says adjust R14 to negitive -2.1V ?????? any suggestions...