Hammerhead Rev D1 parts LIST?

[Winston2021]

Before I make one from the schematic, did I miss one already available here? The list in the Hammerhead Revision 1.5 instructions dated 21 July 2006 is for a previous board version.

[waltr]

Before I make one from the schematic, did I miss one already available here? The list in the Hammerhead Revision 1.5 instructions dated 21 July 2006 is for a previous board version.

All the HH version info I know of is here:
https://www.geotech1.com/cgi-bin/pag...head/index.dat

[Winston2021]

All the HH version info I know of is here:
https://www.geotech1.com/cgi-bin/pag...head/index.dat

Thanks, got all of that already. The parts list in the outstanding Hammerhead construction article is for a previous version. The only info specifically for version D1 found at that link, "Full schematic & placement" has no actual parts list.

[surfdetector]

Thanks, got all of that already. The parts list in the outstanding Hammerhead construction article is for a previous version. The only info specifically for version D1 found at that link, "Full schematic & placement" has no actual parts list.

Somewhere in the Hammerhead thread there is listed the following as corrections to the original BOM:
R17-R18 100k
R30 150k
R33 100k
R39 1k
Pot R34 1M

I found that the Rev D schematic seemed to be correct.

[Winston2021]

Somewhere in the Hammerhead thread there is listed the following as corrections to the original BOM:
R17-R18 100k
R30 150k
R33 100k
R39 1k
Pot R34 1M

I found that the Rev D schematic seemed to be correct.

Yes, I found that, but it didn't mention what version of board if I recall correctly and was about a component value conflict between the parts list and the schematic of an earlier than D1 version based upon the date of the post. I've already started a parts list for the rev D anyway which I will post here when it's done.

[Winston2021]

Found a parts list:

https://www.geotech1.com/forums/show...1641#post51641

[kt315]

a banner on THIS page (web-page) GEOTECH is clickable. CLICK ON IT and go in a section PROJECTS.

[Winston2021]

a banner on THIS page (web-page) GEOTECH is clickable. CLICK ON IT and go in a section PROJECTS.

The Hammerhead instructions on that page contain a parts list that is for a previous version. I wasn't sure if the parts list would be the same for the D1 version. The one I asked for in this thread which I later found and then linked to above is definitely for the Rev. D1 version since the list was created from the Rev. D1 schematic. I found that list immediately after I'd just finished making my own list from the schematic...