Announcement
Collapse
No announcement yet.
Minipulse plus Rev-D STEP 2 - + 5V and +10V - any clues what I've done wrong?
Collapse
X
-
What an eegit I am - always helps to read the instructions carefully - Thank for your patience and help
-
-VE multimeter ..to TP10, with the U4 and U2 in, make you measurements again.
Leave a comment:
-
The problem is that you should be measuring all voltages with respect to TP10 (which is the 0V reference). It does actually say this in Step 1.Originally posted by Having a go View PostWanted to ask about step 2 Minipulse plus Rev-D - I get +5v between U8 pin4 (-ve) and TP2 (+ve multi meter) without the chip U2 in and +10v with the chip in. According to the instructions it should be +5v. Any suggestions what I done wrong? - I've checked all components are correct, in the right way round and checked their values before placing them (chips aside - no oscilloscope)
I'm very much a starter - having failed to get a Surf PI to work, i thought to ask before carrying on.
You are currently reading 10V because you're connecting between the +5V and -5V supplies.
Leave a comment:
-
Minipulse plus Rev-D STEP 2 - + 5V and +10V - any clues what I've done wrong?
Wanted to ask about step 2 Minipulse plus Rev-D - I get +5v between U8 pin4 (-ve) and TP2 (+ve multi meter) without the chip U2 in and +10v with the chip in. According to the instructions it should be +5v. Any suggestions what I done wrong? - I've checked all components are correct, in the right way round and checked their values before placing them (chips aside - no oscilloscope)
I'm very much a starter - having failed to get a Surf PI to work, i thought to ask before carrying on.
Tags: None
Leave a comment: