If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
hi .
thanks gurus . i just work on DP2 and this coil.better coil have 400 too 500mkh and 2 to 4 ohm res.
so i should work on this value or near this. i buy plate and today go to make in circle . just set and adjust this part too hard.but i should work more.
if have more data i happy to put your data here.
regards
My Guess, To get 400 to 500uh and a resistance of 2 to 4 Ohms, you will Need to use a 25 AWG (.45mm) or 26 AWG (.40mm) Wire.
Tweet
Comment