DEEPERS

[maikl]

hi all,

can anybody share a photo of Deepers 8 inside? got Deepers 10DD in repair and would like to compare. The PCB of 10DD looks very similar to the schematic in the thread.

give my regards to your wife

Hi kt315. Did you repair Deepers 10DD? What is the impression left on you - how it works Deepers 10DD?

[kt315]

...

[kt315]

hi all,

can anybody share a photo of Deepers 8 inside? got Deepers 10DD in repair and would like to compare. The PCB of 10DD looks very similar to the schematic in the thread.

give my regards to your wife

[ivconic]

DEEPERS 8 P.SUPPLY NOTE: LM2940 pin 2 connection pin3 LM2910!! Sorry for the mistake.

Don't worry; mistake is my middle name!

[georgi.g.zhelev]

DEEPERS 8 P.SUPPLY

DEEPERS 8 P.SUPPLY NOTE: LM2940 pin 2 connection pin3 LM2910!! Sorry for the mistake.

[ivconic]

[georgi.g.zhelev]

DEEPERS-8 P.S.

50% Size:

[georgi.g.zhelev]

Georgi can you give here more clear pic of power supply? I am wandering about C1/14? Is it 10uF? What is it's orientation on pcb? Kind a uncommon way to wire up 7660? Is it wired as voltage doubler? There is certain disparity between your PS hand draw schematic and pcb... or i just can not see clear pin numbers on 7660!?

Hi, Ivconic, sorry for the delay. I tried to draw a scheme to supply DEEPERS-8, this happens:

[der_fisherman]

no... they are aluminium also here!

I'm drinking 7up right now... it's good aluminium stuff... maybe , one time, it was some B52 fuselage....

Just BS products use iron/steel for beverage stuff.... unless needed (e.g. large containers).

Kind regards,
Max

You should try using a magnet on the side of a cola can, its magnetic, has been for many years. The top is aluminium.
I know this post is a few years old.......but I could not leave it as it was....sorry.
Andy

[ivconic]

DEEPERS


http://www.youtube.com/watch?v=llRkt...eature=related

Georgi can you give here more clear pic of power supply? I am wandering about C1/14? Is it 10uF? What is it's orientation on pcb? Kind a uncommon way to wire up 7660? Is it wired as voltage doubler? There is certain disparity between your PS hand draw schematic and pcb... or i just can not see clear pin numbers on 7660!?

[georgi.g.zhelev]

deeers

DEEPERS

http://www.youtube.com/watch?v=llRktnsZ36w&feature=related

[georgi.g.zhelev]

DEEPERS

Hi,alexismex, Nelson! " DEEPERS", what is news?

[jantnadal]

Hi Alexis, thank you for the data in the integrated circuits if you have any diagram or hypersensitive coil photos you have would appreciate shipped it to my mail [email protected] thanks again.

[jantnadal]

Hola Alexis, gracias por los datos de los Circuitos Integrados si tienes algun diagrama o fotos de la bobina hipersensitiva te agradeceria me lo enviaras a mi correo [email protected] gracias de nuevo.

[jantnadal]

Excuse my way of expressing myself, I've been bad about the death of my mother, sorry for all users of the forum, it is not my intention to be rude, thanks