Hand held Oscilloscope

[Mark-VA]

Okay, tech guys and gals, would this be a good scope/tester to have?

https://zoyitools.com/product/zt-703s/

Knowing how much I like to measure frequencies.

[Riss]

It's almost halved in price - probably has a sales problem due to the low sensitivity - 20mV/div , but it works for your purposes

[ivconic]

Any is better than none.

[Mark-VA]

It's almost halved in price - probably has a sales problem due to the low sensitivity - 20mV/div , but it works for your purposes

What all would - 20mV/div affect if I used the unit for other than detector frequencies?

[Carl-NC]

Keep in mind this is a DMM with a little bit of oscope functionality added. Depending on what you want to do it may be enough, but I would not expect it to perform like a real oscope. 20mV/div is the maximum sensitivity, again it all depends on what you want to do. I rarely use a higher sensitive setting, but just recently I needed 10mV/div with 256x averaging to look at a response. If all you want to do is measure frequencies and see what a waveform looks like, this might be all you need.

[Mark-VA]

Lord have mercy, there are many different hand held scopes on the market. I'm sure some are not so good and others well who knows.

[pito]

I am happy with this one, 1 channel, 2mV, DSO112A

[Mark-VA]

Have you tried to scope metal detectors for transmit frequencies?

[pito]

it is good for frequency measurement, for coil nulling ....

[Riss]

I am happy with this one, 1 channel, 2mV, DSO112A

I have the same one, I feed it with 4 pieces of 18650 in parallel. yes - it works, it's not complete garbage, but it's garbage