The poor availability of custom cut quartz crystals these days was discussed on here before. One solution was MEMS based oscillators, some of which are programmable, some are fixed ( pre-programmed? ). I see that some have quite low operating frequencies, below the usual "quartz crystal range".
Here are some made by Microchip, as examples:
Announcement
Collapse
No announcement yet.
TM 808 White's
Collapse
X
-
-
The resonators should be easily obtained, I checked eBay, there were several sellers. The oscillator circuit is similar to that of a quartz crystal, with some component value changes ( lower resistances, etc ) , so you should be able to use the existing 4011 NAND gates.
And the divide-by-16 can be done with any CMOS counter, such as the CD4024.
Leave a comment:
-
Your crystal problem could be solved by using a 420 kHz ( or 429 kHz ) ceramic resonator, and dividing it by 16.
This gives equivalent crystal freq and operating freq of:
420 kHz > 26250 Hz > 6563 Hz ( and 429 kHz > 26813 Hz > 6.703 Hz ) These resonators are used in TV remote controls, mainly, but also some radio IF circuits instead of 455 kHz.
Leave a comment:
-
I still can't find the xtal 26.37khz or 211.2....
How did you solve it?
These are my TM808 files
TM808 BERREIZETA.rar
- Likes 1
Leave a comment:
-
-
Leave a comment:
Leave a comment: