PG3B PROGRAMMER

[MAURICE]

Greetings
I was looking on web and found pic software which supports a large number of Microchip pic's. It also has GUI. for windows and Linux (freeware).
Software is PICPgm Perhaps someone can add Hyperlink ( computer challenged).
It supports PG3B parallel port programmer. There are are also a few other programs that will work.
PG3B can be found at www.olimex.com.
I am no pic expert but will give this one a try.
I would appreciate some feedback on the images in zip.file.
I think everything is okay please check and let me know.
Regards
Maurice

[MAURICE]

HI
Found 1 mistake no vcc on Q2 corrected and marked with X on schematic.
Redone zip file.
Maurice.

[MAURICE]

Hi.
PLEASE HOLD ON IF MAKING PCB .
I was only able to buy 25pin socket today to check orientation on pin one.
I had it wrong way around.
The PDF and schematic are okay but I have to rotate socket 180 and re-route board.
As soon as I have done this will post.
Regards
Maurice.

[MAURICE]

Greetings.
I have corrected board layout , socket now right way around.
A little smaller size= 97.15mm X 73.03mm.
No feedback ?
Maurice.

[MAURICE]

Hi
I have had more time to thoroughly check everything.
The PDF is original source, the schematic in zip - rev A correct( my diptrace schematic)
and the board layouts zip rev B have now been checked by me. I don't want to re post everything until requested to.
Regards
MAURICE.