For sale bare boards for Delta Pulse/Sniffer XR-71

[ossdr]

Hi k315
Please tell me what's these pin's
T3
T4
T5
T6
T7
E+
E-

[chuubaba]

[dbanner]

Wait for more instructions, don't attempt to do anything!

[chuubaba]

MOSFET and coil connected with board. I installed all old IC.
The board is working again.

[kt315]

good. leave it. set mosfet back and test with small coil.

DO NOT CONNECT A METER COIL IN YOUR ROOM/HOUSE/HOME.
ANOTHERWAY YOU WILL BURN SCHEMATIC.

[chuubaba]

T3 minimum pulse width is 180uS. The maximum is 550uS.
C3 is 18nf.
Is this ok or i change C3 to 15nf ?

[dbanner]

The DP board is "On" for a while and no components are hot. Should i install the MOSFET ?

DO NOT DO ANYTHING!!!!! YOU MUST WAIT FOR FURTHER INSTRUCTIONS FROM KT315.
You are like wild horse, always bolting from the stable!!!!

[chuubaba]

The DP board is "On" for a while and no components are hot. Should i install the MOSFET ?

[chuubaba]

Look at this smiley {}

Are these two hitting each other with punches ?

[chuubaba]

The diagnosis was not possible without your expert mind.
You are the best

[chuubaba]

I bed your pardon. The power plug was "off"

Yes it working now.

[chuubaba]

But there is "no sound" between BAT- and -12v

[kt315]

ok. connect wires from power supply and look on LEDs.

[chuubaba]

take a piece of naked wire (cutted pin of resistor or cap) and solder its ends on both sides of board via hole.
on pics

[ATTACH]48165[/ATTACH]
[ATTACH]48166[/ATTACH]

I have soldered as shown in the pictures.

[kt315]

take a piece of naked wire (cutted pin of resistor or cap) and solder its ends on both sides of board via hole.
on pics