For sale bare boards for Delta Pulse/Sniffer XR-71

[chuubaba]

I meant the same thing and it shall be done.
Thank you very much for your attention.

[kt315]

Sheilding the board will cerainly improve the performance but will it be sufficient?

i ask you again do not ask me idiotic doubling questions.
if i say TO DO that is mean only (ONLY) TO DO, without your sufficient fantazy and 'will it be or will it be not'.

[kt315]

i did not mention to shield a board. read attentionally what i write pls.
SHIELD ENCLOSURE INSIDE. look especcialy created album https://www.geotech1.com/forums/album.php?albumid=102
you must sniff every pic now and notice every detail.

[chuubaba]

Sheilding the board will cerainly improve the performance but will it be sufficient?

[chuubaba]

I made round shaped 500mm coil. It is 400uh. 2.15 Ohm resistance.
It's detecting a 400ml can of WD40 upto 43cm. I am not impressed with depth.
What can be the cause?

Also the test coil was giving excellent iron rejection but with 500mm coil the discrimination is gone.

[kt315]

ok

What minimum size coil i can use with this ?
Thank you very much for assistance.

on pics

[chuubaba]

I have installed all tantalum capacitors.

[chuubaba]

ok

What minimum size coil i can use with this ?
Thank you very much for assistance.

[kt315]

yes. solder tantalums on bottom side.

[chuubaba]

The testing is complete?

[kt315]

you have to shield a case and then put the pcb inside.

[chuubaba]

Ok Now it is detecting copper.

[kt315]

increase DEPTH and SENS, look a reaction on copper.

[chuubaba]

set 1st probe on T3, 2nd probe on T1. 0.5V/div, 10us/div.

[ATTACH]47938[/ATTACH]

I have this result

T1
T3

[kt315]

set 1st probe on T3, 2nd probe on T1. 0.5V/div, 10us/div.