BARACUDA-Legend-1

[kt315]

i suggest you to go in a school near you and to tell with a teacher of physics about '230 VOLTS AC', what is it, for what is it, and common achievements of a civilization
in the Electricity.

[Deghbar613]

do you test out your home or inside your room? on backyard? at field faraway from your town?

i am only test inside my room

[kt315]

do you test out your home or inside your room? on backyard? at field faraway from your town?

[Deghbar613]

Voltages & Frequencies (Hz) Around the World - Generator Source

thx kt315
but i am using 12v batt

[kt315]

Voltages & Frequencies (Hz) Around the World - Generator Source

[Deghbar613]

Algeria

I didn't understand what mean (you have big influence from 50Hz power line).

[Deghbar613]

you have big influence from 50Hz power line. re-tune Bara on sure 600Hz. (50 multiplay on 12)

what is your country?

Algeria

[kt315]

you have big influence from 50Hz power line. re-tune Bara on sure 600Hz. (50 multiplay on 12)

what is your country?

[Deghbar613]

This U4 PIN4 do you think is ok ?

[Deghbar613]

Hi Deghbar613,
Sorry I saw your post late.
If the pulse width and cycle length are stable, then what you show on the oscillograms is very similar to a malfunction in the input circuit (partial discharge).
Check for problems with the damping resistor and the serial resistor and the health of the clamp diodes.
If they are OK, it is most likely a shortening of the cable or between some turns of the coil.
Try a different coil and cable.

PS:Also check the space between the incoming rails, mostly around the high-voltage rail (MOSFET drain).

Hi boilcoil thx for reply
i change coil but its the same problem
i am beginner but i think the problem is from the mosfet is fake. i don't have other one to change it