Tweet
Hi all I'm putting together the TGSL that I began to arm QIAOZHI posting coils and finish as the post says the coil RX and TX 107 laps 98 laps right now as I do not have a measuring inductometro gives me strength and nearly equal RX = 9.7 TX = 9.8 ohm ohm this is good or has to be greater resistance diferncias between coils
-
-
Hi,
You need to achieve 6mH for tx and 6.5mH for rx. It's the inductance and not the resistance...
Your resistance is too low and in my mind, your wire
is too big!
It's not 0,25mm?
Good luck for your project!! -
inductance
if I understand the difference between inductance and resistance, the question is.
with a coil resistance well calculated that would have to be when measured with a tester
so I could more or less know or come close to this ideal inductance
PS: the wire is 0.25mm might not be appreciated by the photo too closeComment
-
If you have followed the instructions provided by Ivconic, even without an inductance meter, you should not have a problem. You're main difficulty will be balancing the coils correctly, but Ivconic has even provided a simple method for doing that.Originally posted by Tekeweke View PostComment
-
calibration coils
Thanks for replying do you know the link of this post I have enabled status seeking but can not find greetingsComment
-
Everything you need is here -> http://www.geotech1.com/forums/showthread.php?t=15710Originally posted by Tekeweke View PostComment
-
Tank you Qiaozhi
Comment
-
Hello,
forum member selim made a video of his working tgsl
he wrote that he uses for his rx coil 14mH
and only one of his coils is shielded i dont know rx or tx
but it seems to work
can anyone confirm that
the other fact is that some users take metal cases for tgsl other plastic cases
can i increase performance when using metall case
which cables should i connect to metall caseComment
Comment