Tweet
Has anyone took the Deus 2 audio jack module for the ws6 puck and hard wired it into a set of full size headphones for true wireless operation without the coiled headphone cord seems pretty straightforward in theory but might be more difficult than a few soldered in wires, anyway if someone has done that and it worked please let me know how it worked and if there’s anything to be aware of while modifying,thanks
-
-
It's quite simple; I did it with a WS4 for a Deus, and the principle is the same.
Take an audio module (same as ORX, Deus, Deus 2), remove the jack plug, and solder two wires to the back.
I countersunk three existing holes in the module to accommodate three stainless steel countersunk screws (M2.5x8mm).
They protrude slightly to allow the WS4 to clip into place.
A Bakelite plate was cut to fit inside the WS4 (it's slightly smaller than the audio module in width and length).
I made a square notch in the Bakelite that corresponds to the four solder points on the back and the cable entry point.
The connection is very simple: a positive and a negative. Generally, the positive terminal is on the right when looking at the back of a speaker.
Comment