felezjoo PI(the best pulse induction metal detector that I made until now)

[RS_Phil]

Is that chicken code is a full version? hahaha!..

[jladre]

A rooster audio?!??
What is that version of code!???

...

Hahaha!! Thats a real rooster. A fighter cock. it is called chicken code.hahaha

[ivconic]

Now i have to run my machine without lcd.https://m.youtube.com/watch?v=gG0qjZm0m58

A rooster audio?!??
What is that version of code!???

...

[jladre]

Now i have to run my machine without lcd.https://m.youtube.com/watch?v=gG0qjZm0m58

[jladre]

Ive check everything and i really suspect that lcd is the problem.. I going to replace a new one.

[Davor]

Most probably it detached from its base. There are rubber-like contact ribbons that provide contact between a LCD base and a LCD glass, and those are notoriously flimsy. That's one of the reasons I hate LCDs for terrain use. You may try to fix it, but your better choice is to simply replace a whole LCD and avoid hours of frustration.

[ivconic]

After transfering all parts to my new easy open waterproof box my lcd seems damage. Can anyone tell what would be the problem? I had already check the wirings and it is good and correct. Lcd display photo is below.
[ATTACH]35630[/ATTACH]

Either is broken either you swapped wires.
Also check paths from Atmega to LCD.
Check all over again.

[jladre]

After transfering all parts to my new easy open waterproof box my lcd seems damage. Can anyone tell what would be the problem? I had already check the wirings and it is good and correct. Lcd display photo is below.

[ivconic]

...


Ask me anything about AVR top secrets... and i'll be glad not to answer you!

[RS_Phil]

Hello again. My PI md works, after setting correct fuse bits .It works well with all my coils of previous projects. But there is a new problem, count of starts is not reset after reprogramming atmega 328p .It is against the following-At the end of 300 times,with a programming can be re-used again and again to set up the system. Doesthissoftware solution ?

Low Fuse: F7 High Fuse: D9 Extended Fuse:FC

[TreasureHunter]

by the way how sensitive is this detector? I read somewhere that Pulse Induction detectors are not too sensity, and good only for big items.

[TreasureHunter]

can I get the ".sch" and ".brd" files for the project please?

[jladre]

OK.Thank you. With AVR Studio 4 was able to do everything. Programmer MKII. What size of the coil is recommended? I have several 20 cm , working well for now.1.6 om - 330 mkh

any size will do!

[timekiller]

OK.Thank you. With AVR Studio 4 was able to do everything. Programmer MKII. What size of the coil is recommended? I have several 20 cm , working well for now.1.6 om - 330 mkh

[ivconic]

Hello again. My PI md works, after setting correct fuse bits .It works well with all my coils of previous projects. But there is a new problem, count of starts is not reset after reprogramming atmega 328p .It is against the following-At the end of 300 times,with a programming can be re-used again and again to set up the system. Doesthissoftware solution ?

You missed to read all the posts from the beginning, i explained that earlier.
Variables which are set and further changed by working code are stored in internal Atmega's eeprom (1kb).
So, to overcome that problem; you must erase eeprom content.
Simple reprogramming Atmega with hex code will not overcome the problem.
Erase internal eeprom.