My Digital Pulse detector Delta Pulse 3

[jap]

thank you for reply.

but part4 in reply#356 about glcd jap/

Hi hadi-dindar
-for -read reply#356--->part 4,,,,,Previous defect.
-for new defect,,,,test T9,T10,T11,Q6,D4
-test Q3,Q4,D6,,Notable: Q3 is Partial damage from extreme heat...attention!!!
best time
j.

[hadi-dindar]

thank you for reply.

but part4 in reply#356 about glcd jap/

[pigeon]

Hi hadi-dindar
-see rar
-read reply#356--->part 4
Full wishes for the success to complete
best time
j.

hi

the pass is jap

[grozendqvol666]

pass???

[jap]

hi jap

thank you for your help.

i have one problem . i make dp3 . but the current of my coil is only 15ma . i change irf840 but not solve my problem .

and my coils is 20 cm via 3.5ohm resistance

Hi hadi-dindar
-see rar
-read reply#356--->part 4
Full wishes for the success to complete
best time
j.

[hadi-dindar]

hi jap

thank you for your help.

i have one problem . i make dp3 . but the current of my coil is only 15ma . i change irf840 but not solve my problem .

and my coils is 20 cm via 3.5ohm resistance

[RS_Phil]

I think there is problem of fuse configuration settings...what programmer did you use?

[hadi-dindar]

ok malibu
please speak english .
?

[Malibu]

hello hadi-dindar
I read in turkish forum that you ask about, sarj and yedek aku. do you understand yet? can you say me something?
thanks.

[hadi-dindar]

HI friends

I have one problem about Calibration of signal coil. and i Get Video of this problem

Its not correct Exponential . and i have Horizontal line in nether of GLCD.

please help me to solve this problem . the threshold sound is in 49 and it very low.


link of video

http://hadi-dindar.persiangig.com/video/19032013043.mp4

or download here

[hadi-dindar]

my problem solved . i have one open circuit in lcd connections

[Malibu]

hello all people.


thank you jap.


can anybody recomend me a battery? how many Ah, do you recomend? one or two batt ?
In P4 sarj, i put ac 12 volt adaptor, and in P3 in pin 1 and 2, I put sw on/off.

if I want to put 2 batt, one goes in besleme. and the other? in P3 or in serie with the other?

I'm missing with this. I don't understand what make the sw on/off.
any suggestion.
thanks guys

[hadi-dindar]

hi jap

hi jap and other best friends

i have one problem
when i install pic on pcb and want to turn on the detector my glcd can ton ably to show all thing .
please attention the this images

[jap]

Hi jap,

first thanks.


and another question,

i solder the holes like in the file "output job" ? the red lines?

is the good file?

Thank you, very much.

Hi Malibu
-Yes,file "output job" are v.good,,,,,,,,read reply#356 .
best time
j.

[Malibu]

Hi jap,

first thanks.


and another question,

i solder the holes like in the file "output job" ? the red lines?

is the good file?

Thank you, very much.