Hello minipulsers

[qute1]

Could you draw me a diagram of how this coil should be connected? i am at a loss but i am starting to suspect the tx oscillator also off to have a looky googles down probe at ready

[Qiaozhi]

Could you draw me a diagram of how this coil should be connected? i am at a loss but i am starting to suspect the tx oscillator also off to have a looky googles down probe at ready

Just move the coil wire from the middle pin of the TX input to the middle pin of the RX input, and remove the bridge. Then the TX oscillator will be driving the coil, but with the RX disconnected.

[qute1]

Cracked it D1 1n4148 was defective replaced and all running perfect now thanks so much Q and waltr i persevered thanks to your input when otherwise might have given up you guys rock.

[Qiaozhi]

Cracked it D1 1n4148 was defective replaced and all running perfect now thanks so much Q and waltr i persevered thanks to your input when otherwise might have given up you guys rock.

That's good to hear.

[waltr]

Yea, that's great.