King Cobra PCB

[growdude]

Still no luck all i can find is min.order 250 or more

Sorry I've been up for 32the hours.

[Merc]

And ICL7660.

Merc

[Merc]

Try LF442.

Merc

[growdude]

Parts source

Does anyone have a source for the LM442 and LMC7660 I can't find them

[kt315]

updated.

[kt315]

added some capacitors.

[growdude]

Adding pot for ground balance

I'm making a king cobra clone very soon. I'm adding manual ground balance 10and turn like.on the gold mountain GMT 1650.is it possible to amplify faint target signals without blasting good targets? And possibly adding volume control.and could an led read out of ground balance be done such as -and + like +3.5 or -2.8

[satdaveuk]

Agree, most probably is the same coil as for Golden Sabre etc...
I didn't draw pcb for it yet. Not sure if i will ever. Because; basically it is the very same "platform" as Golden Sabre. Except use of 7660 instead 4024 and those 2 transistors in negative supply. Is it better? Maybe it has better features with 7660? Maybe not. I am not sure.
And of course; unlike Golden Sabre, Cobra has ppoint mode (static, nonmotion). Nice. If i ever decide to draw pcb for it i would probably exclude Notch part again...

Taking of pinpoint mode, could this be extracted to work on your TGSL ?

Regards

[growdude]

I cant see the images

Is it just me I can see the images you listed kT315

[kt315]

renumbered

[kt315]

For KT315
U1 pin 8 : add 100P on Ground.
U12 pin 1 : add 470k to +V
R75 : to -V
R27 : 10k or 1k ?
PCB rectified (1-2):

- my PCB has not the 100 pF on GND, but a place is there, so I added it.
- OK.
- no link to -V. really N.C.
- R27 is 1k.
also still change U3.2 pin 6 100pF, U14.2 6-7 pin 220k.

thanks.

[Patrick]

For KT315
U1 pin 8 : add 100P on Ground.
U12 pin 1 : add 470k to +V
R75 : to -V
R27 : 10k or 1k ?
PCB rectified (1-2):

[kt315]

Can you post a pic of PCB that I can print my own board from in black and white I have a mint king cobra and I want to build my own before I sell it.I have original king cobra shafts and boxes to use.

any data on the coil can tell anything about? resistance? inductivity? resonance frequency? on TX and RX part saparately.

[growdude]

King cobra pcb

Can you post a pic of PCB that I can print my own board from in black and white I have a mint king cobra and I want to build my own before I sell it.I have original king cobra shafts and boxes to use.

[kt315]

preliminary release, without right numbering. please check values.