IDX-PRO+VDI

[Koala]

6.59KHZ for both TX and RX when connected normally to the detector just the phase between the two is different.


RX on its own is 4.6 kHz but can be a fair bit out and still work okay.

[basellafe]

Hi I have rx frequency about 400hrtz and tx is 6570khrz is that normal

[onuba]

http://www.youtube.com/watch?v=u6SoCvBTjV4

hello someone helps me safe VDI fuses lugatek

[jlsilicon]

I tried wiring the IdxPro on a Breadboard for testing.

But, I don't see any fluctuation with Metal across the Coils.
I Nulled it out with an Oscilliscope.

I was hoping to see flutuation with Metal, on the Oscilliscope.

[Emiliano_070]

https://youtu.be/tYsIPEsptVA.
hello .vdi not see almost nothing, what problem will.

[Koala]

someone would have data concentric coil for idx pro ?
thanks maxm3s

http://www.geotech1.com/forums/showthread.php?20315-Concentric-coil-for-IDX

[maxm3s]

someone would have data concentric coil for idx pro ?
thanks maxm3s

[Emiliano_070]

Hello comrades, I look for a scheduled IDX.esperó PIC that can help.

[nando.22]

idx -pro there is no discrimination

[CDI]

What i can see from first look, u have minimum 7 - 8 bad soldered pins. Solder that again, clean with alcohol, let it dry and try again. Good luck.

[maxm3s]

[maxm3s]

[CDI]

help me
my md only works in pinpointer mode
https://www.youtube.com/watch?v=w-DH-vFUDuI

Look's like not well nulled coil. Did u measured pin 3 from U1? Must be less than 200mV.
Also, attach clear photo's from pcb...

[maxm3s]

help me
my md only works in pinpointer mode

https://www.youtube.com/watch?v=w-DH-vFUDuI

[nando.22]

DD coil 27cm and correct