Originally posted by Carl-NC
View Post
Today, i adjust frequency to 4.7kHz. The other settings is as following:
TX Pulse width = 26uS
Delay = 6-7 uS
All sample width = 20uS
I figure out timing diagram and adjusted EFEs and GB delay.
Now, my PI works very nice but i unfortunately have too much noise at home. I will test outside and report back here.
Dear Carl, i have a question about TDI. As you know, TDI frequency is high near 3kHz. Do you think its TX pulse width is low?
Generally, Do you think TX pulse width can effect on depth detection?
Leave a comment: