TGSL SMD

[dbanner]

You have to connect TX coil to get correct power supply voltages. Did you try it with Tx coil connected?

[ripsdevala]

The board using 1206, i use any smd size i find

[BKY1337]

Ok, did you use 1206 parts?

[ripsdevala]

Tgsl, same thing with original v1

[BKY1337]

Is this IGSL or TGSL? I need one from the IGSL smd.

[ripsdevala]

A little bit big for 4024 smd to dip
tgsl_smd_V1 rrrrrr.lay6.zip

[BKY1337]

Sorry , i cant help you. But i like this layout.
How big is it and can you upload the .lay file?

[ripsdevala]

Hello there...
Board already fill up, with 4024 dip


Why i not get ussual -6.2v? Only -0.6v
8v normal
4024 pin12= 5.5v

[BKY1337]

Thank you!

[dbanner]

As far as default values, you'll have to check pcb manufacturer website to see what there parameters are in terms of min. and maximum sizes for holes, track width etc. I think deafault values are well within specs.

[dbanner]

The solder mask is the part of the bottom layer(and top layer if this was double sided board) which is covers entire board. What you are seeing is the gerber negative which shows area which will not be covered by mask. Obviously you don't want to mask the places to be soldered. Your files look OK.

[BKY1337]

I know now what my Mistake was. I used one gerber file from my barracuda, this was the wrong blue layer.

:-)

[BKY1337]

Yes because i edited it three times. Your picture looks good. I had the bad result with online gerber viewer. It looks good in sprint layout.

Do you think i can use the default values for the solder mask?

Edit: My blue layer is the solder mask.

Thanks!

[dbanner]

The board does have a bottom layer, it's the layer C2 which is green in sprint default, the blue is top layer which this layout does not have.

[dbanner]

Each time you post, your last post disappears.