Your opinions matters

[green]

I use EZ-SLIDE graphite brush on coating for shielding. Works for me. Just finished an IB coil for a PI. Looked at amplifier out while bringing my hand to the coil with a scope before shielding. The change in signal was a lot greater as the TX coil was discharging. A small change if any on the scope after maybe 6usec. Change at integrator out so the coil needed shielding. Since the change in signal is higher when the TX is changing, is it harder to shield a VLF detector? Haven't tried the Nickel, Carbon or Silver spray.

[Tibuck19]

Coil shielding , opinions on MG Chemicals, Nickel vs Silver vs Carbon, Which would make the better shielding coating, for both PI and VLF coils. I know there is a lot of talk about scotch24 shielding tape but it is rather hard to get a hold of.

https://www.amazon.ca/MG-Chemicals-C.../dp/B005T8O7X4