Sovereign Coil.

[kt315]

thanks. did you see these photos? it is Excalibur and a coil.

http://photofile.ru/users/tutanhamon_2/96524279/120607726/

[for ivconic - the photos are NOT MINE. I open coils without an hammer!]

[Geo]

thanks. did you see these photos? it is Excalibur and a coil.

http://photofile.ru/users/tutanhamon_2/96524279/120607726/

[for ivconic - the photos are NOT MINE. I open coils without an hammer!]

Hi. This coil (BBS 1000) seems to be the same with the Tornado BBS 1000 that it used by the Sovereign

Regards

[mario]

Awesome work Geo!

Where did you get the housing?

[Geo]

Awesome work Geo!

Where did you get the housing?

Hi.
Read some posts before....

http://geotech1.com/forums/showpost.php?p=117971&postcount=41

http://www.mdushkov.hit.bg/

[MLR]

Hi.
Are you the owner of the site???

Oh, no These coils are produced, as you can see on the site, from 2002, or maybe earlier, don't know exactly I put this site here only for your information, because these coil housings are cheap - between 3-5 Euro in the SHOPS!!! But from some other producers they was offered
more, more expensive in some forumsfor example russian

[kt315]

Oh, no These coils are produced, as you can see on the site, from 2002, or maybe earlier, don't know exactly I put this site here only for your information, because these coil housings are cheap - between 3-5 Euro in the SHOPS!!! But from some other producers they was offered
more, more expensive in some forumsfor example russian

i do not know what you mean wrote russian. yes, i read feedback of Ciklon about these coil housings he got from anyone in Bulgaria... he critically wrote that they were done from thin plastic.

[MLR]

Thin? No, don't think so, but you have right about the criticism - maybe are made from reciclat

[philippehobby]

Hello,

I measured around 400 mV at preamp output, can I consider my 8" excalibur coil well null balanced.
If not what can I do, I opened the coil, still functional, I can see the 8 shape small coil in serial wit Rx to null balanced and make all the measurement before the amp op
Thx
Philippe

[Geo]

If preamp has a gain near to 40 then the output of coil is about 10mV. It is not so good for a commercial coil , but if you see it from the other side... not so bad.
I don't think that you can do many things...
You can try to put a small coin on the coil and to move it left ... right.... etc. If you see a better null then glue it on the coil.
But i am not sure if it will work.