felezjoo PI(the best pulse induction metal detector that I made until now)

[samii]

Hello
if you will use IRF740 will not get coil error or open device first and connect coil.

[basellafe]

Thanks juse for reply i have tryed to post some photo buti couldnt i dont no why but i will try again so my board i use lf356 and irf 840 resesters is 5%tolerance no tantaliom capaceters only electrolic and ceramic for 104 code i use ivica pcbmy coil i onnected it directly its tow coil one of them is 22cm with31 turns and the other is spider 19 cm with 27 turns fuses is normaly as it should be

[jladre]

what cuse error coil. all the time with many tries lhave error coil

Post a photos of your board, cable, and coil.....a clear photo that our eyes can spot the problem.

[basellafe]

what cuse error coil. all the time with many tries lhave error coil

[ripsdevala]

hi thank you allfriend for help.

the usbisp not work

Ripsdevala can you send your pcb

Sure

Is there a way to make felezjoo to be in motion (dynamic) mode?, any MD with non motion (static) mode is not working properly here, to many vulcanic ground.

UP...

[pigeon]

Try this driver, if this fail you need chinese driver to work like my usbasp
http://www.fischl.de/usbasp/usbasp.2011-05-28.tar.gz

hi thank you allfriend for help.

the usbisp not work

Ripsdevala can you send your pcb

[ripsdevala]

Try this driver, if this fail you need chinese driver to work like my usbasp

http://www.fischl.de/usbasp/usbasp.2011-05-28.tar.gz

[basellafe]

https://youtu.be/ZeJ7qDxvIKA

[chevesne]

Firmware files and drivers for older AVR/Atmel Studio and/or Arduino/AVRDUDE

https://www.olimex.com/Products/AVR/Programmers/AVR-ISP-MK2/resources/AVR-ISP-MK2-Firmware-WindowsDrivers.zip

Recommended drivers for Windows 10

https://www.olimex.com/Products/AVR/Programmers/AVR-ISP-MK2/resources/DRIVER-MK2-AS-6-7-W10.zip

Source

[pigeon]

thank you
i have USBisp not usbasp/Is what they are the same

i haven't driver Where can I find

[ripsdevala]

[ATTACH]38546[/ATTACH]

Your usbasp is not recognized, are you already install the driver?

[ripsdevala]

Is there a way to make felezjoo to be in motion (dynamic) mode?, any MD with non motion (static) mode is not working properly here, to many vulcanic ground.

[pigeon]

hi all friend


I have usb isp adapter .i can't burn atmega328 with it

what should I do

please help me

thank you[ATTACH]38545[/ATTACH]

[ripsdevala]

hi all friend


I have usb isp adapter .i can't burn atmega328 with it

what should I do

please help me

thank you[ATTACH]38545[/ATTACH]

Make this for simple programing

http://www.geotech1.com/forums/showthread.php?23181-ICDUINO&highlight=Icduino

[pigeon]

hi all friend


I have usb isp adapter .i can't burn atmega328 with it

what should I do

please help me

thank you