Announcement
Collapse
No announcement yet.
Delta Pulse
Collapse
X
-
-
I share with you Eclipse, that it is necessary to add a series resistance of 1 to 2 ohms, for a better operation of the coil of 1 X 1 m.
The total resistance measured with an ohmmeter should be 2 to 3 ohms.
Resistance of the coil, less than 2 ohms, makes the DP unstable.
Jose
Leave a comment:
-
1x1 coil with 12 windings (1mm2 diameter of wire) - this is my coil parameters and it gives 650uH.
My guess is 10 windings of 0.75mm2 wire will give closer to 400uH results and I've reduced the cross section because lower number of turns will also give lower resistance of the coil (around 1.5 Ohms which is too low), you may need to add 1-2 Ohms resistor at 3-4 Watts.
Leave a comment:
-
all ok thx, solder stop was problemOriginally posted by kt315 View Postufff,,, i am not able to delete top silk layer... write me what color you prefer for silk and i ll remake.
[ATTACH]37845[/ATTACH]
but black white picture is ok
Leave a comment:
-
1mx1m coil has to have 12 turn of wire. measured value has to be 350-450uH.
Leave a comment:
-
kt315 master
most suitable what should be the values of the coil
thanks
Leave a comment:
-
-
Leave a comment: