Announcement

Collapse
No announcement yet.

Delta Pulse

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • kt315
    replied
    i changed a date on sch you see its last.
    Attached Files

    Leave a comment:


  • kt315
    replied
    We arrived at the place, saw on the digging of the pit,
    a close signal was found from them, more precisely, two,
    and deep and horse around.


    0:58 a work by corner, some kinda pinpointing. take attention on this trick.

    Leave a comment:


  • kt315
    replied
    did dig up the second half of the dugout fromh the previous video.

    Leave a comment:


  • andon80
    replied
    thanks kt315what should be the best ohm

    Leave a comment:


  • Jose
    replied
    I share with you Eclipse, that it is necessary to add a series resistance of 1 to 2 ohms, for a better operation of the coil of 1 X 1 m.
    The total resistance measured with an ohmmeter should be 2 to 3 ohms.
    Resistance of the coil, less than 2 ohms, makes the DP unstable.
    Jose

    Leave a comment:


  • eclipse
    replied
    1x1 coil with 12 windings (1mm2 diameter of wire) - this is my coil parameters and it gives 650uH.
    My guess is 10 windings of 0.75mm2 wire will give closer to 400uH results and I've reduced the cross section because lower number of turns will also give lower resistance of the coil (around 1.5 Ohms which is too low), you may need to add 1-2 Ohms resistor at 3-4 Watts.

    Leave a comment:


  • bernte_one
    replied
    Originally posted by kt315 View Post
    ufff,,, i am not able to delete top silk layer... write me what color you prefer for silk and i ll remake.

    [ATTACH]37845[/ATTACH]
    all ok thx, solder stop was problem
    but black white picture is ok

    Leave a comment:


  • kt315
    replied

    Leave a comment:


  • kt315
    replied
    1mx1m coil has to have 12 turn of wire. measured value has to be 350-450uH.

    Leave a comment:


  • 6666
    replied
    Originally posted by kt315 View Post
    reformulate your request in more international english form pls. i can not grasp what you write/want.

    I think he is asking for the coil specifications.

    Leave a comment:


  • kt315
    replied
    Originally posted by andon80 View Post
    kt315 master
    most suitable what should be the values of the coil
    thanks
    reformulate your request in more international english form pls. i can not grasp what you write/want.

    Leave a comment:


  • mschmahl
    replied
    Nice. Thank´s a lot for the info´s and the video.

    Leave a comment:


  • andon80
    replied
    kt315 master
    most suitable what should be the values of the coil
    thanks

    Leave a comment:


  • kt315
    replied


    did dig up the signal from the previous video,
    it turned out that this is really the dugout,
    caught in one of the corners, where there was a stove.

    Leave a comment:


  • kt315
    replied
    will upload some videos with speedy translate.


    Search by plowing, using aerial photography, GPS and the deeper.
    Often there are questions about how to understand the depth signal or not,
    so we decided to shoot the video found on the dugout.

    An autopsy will reveal what's down there.

    Leave a comment:

Working...
X