Hattusa Pulse

[cankur]

Thanks, i will try

[Hattusa]

Hattusa detector apk has not been fully tested yet. But it works, can you install it on your android phone and share the results?

[Hattusa]

Nice work.

On p 3/6 POWER SETTINGS:


you probably mean microseconds(us) instead of milliseconds (ms) ?
1 kHz = 1 ms = 1000 us

right, it must have escaped my attention, 1khz =1mS

[wtrk]

Thank you brother , I will test it soon

[BC547]

Nice work.

On p 3/6 POWER SETTINGS:

Our
detector works at 1khz. 1 khz = 1000mS time. we use 10% of this time (ie 100mS)
as duty and 90% (ie 900mS) as cycle. If the user wishes, this 100mS duty time can
be set as minimum 50mS and maximum 200mS. but the software preset is
100mS.

you probably mean microseconds(us) instead of milliseconds (ms) ?
1 kHz = 1 ms = 1000 us

[Hattusa]

I have prepared the very boring hattusa detector user guide for you and present it to you. I will complete 1-2 minor shortcomings in the code part of the detector as soon as possible and share it here. It takes about 1-2 days. because I'm pretty busy right now. Hattusa User Manuel V0.pdf

[Hattusa]

My hattusa design is closed to your suggestions. I am currently preparing the user manual. It will be finished very soon and the detector's hex code, android apk, PCB schematic and open schematic will be published.

[Hattusa]

Which screen do you think I should use?

[Hattusa]

The design of the detector is finished, it seems that it will not fit in this box with a 16x2 LCD. When I put the batteries, card and LCD screen in the box, the height of the box will not be enough. Would it be better if I use a 128x64 OLED screen?

the detector is currently operating in single mode. in this mode;
1. precious metal-non-precious metal separation
2. threshold setting
3. sensitivity adjustment
4.sound level adjustment

I wonder if I add another mod, I will destroy the reaction of mineral, stone and brick in this mod, do you think it's appropriate?

[Hattusa]

Did the project die?

I came back to my house, we can continue the project in 1-2 days.

[jeep6789]

Did the project die?

[jeep6789]

hi how you

[Hattusa]

hi Thank you for your answer, I have passed some experiments, and I can finally make almost all PI detectors doubled, and it is a stable operation, although it is an analog circuit, because I will not

I have a bit of a busy life in my private life, I will continue the project when I finish. I think it will take 1 week. The data exchange between the apk and the detector was the last thing left.

[jeep6789]

hi Thank you for your answer, I have passed some experiments, and I can finally make almost all PI detectors doubled, and it is a stable operation, although it is an analog circuit, because I will not

[Carl-NC]

On the transmit side, it's all about ampere-turns. On the receive side, it's all about turns and minimum delay. It gets much harder as you reduce the voltage, and current consumption goes up considerably.