'KROT2-XM' (mole), new project Xmega32

[reiv]

Nice CC Why You haven`t got A=0 ? And this new software 0.9ver. is for resonanse frequency above 8kHz, not 7,5kHz like 0.8ver.?

[Ropcsika]

Why you use so low sensitivity ( for ferrous objects???

just tried it

[Ropcsika]

Very nice. Did you try to compare concentric and DD response? (VDI stability, object orientation, range etc). I have built only DD but want to try concentric design. Unfortunately whole thing is not finished yet, not boxed, everything is still on working table.

Yes I have compared. All the same (VDI stability, object orientation, range etc). works well.... This is a IDX Pro coil...I tried...

[Ropcsika]

Nice CC Why You haven`t got A=0 ? And this new software 0.9ver. is for resonanse frequency above 8kHz, not 7,5kHz like 0.8ver.?

A=0 after auto balanc A=534...
I'm trying the different frequencies and softwares

[ANDREW K2]

In modern dwellings many industrial noise.
Therefore, the device should be tested in the field or the woods away from the noise. )
But at home, too, you can check your device to turn off this coil
set thresholds S22 or S33. In this "false" signals there are no or very rarely.

[Ropcsika]

In modern dwellings many industrial noise.
Therefore, the device should be tested in the field or the woods away from the noise. )
But at home, too, you can check your device to turn off this coil
set thresholds S22 or S33. In this "false" signals there are no or very rarely.

I turn off the coil, the first minute there are 3-4 false signal but after total silent or very very rarely....

[ANDREW K2]

[Ropcsika]

With new firmware (v09sa) simple adjust the coil balance...

[reiv]

Anybody knows what is the optimum voltage Rx measured on coil`s ends ? I just know it must be below 1V at output AD8091, soe maximum input should be below 10mV but more precize?

[smity]

Attention, attention! For good video (video report), the author will send the new firmware v.10 for Mole 2!

[Geo]

Anybody knows what is the optimum voltage Rx measured on coil`s ends ? I just know it must be below 1V at output AD8091, soe maximum input should be below 10mV but more precize?

1...2mv is very good.

[Geo]

Attention, attention! For good video (video report), the author will send the new firmware v.10 for Mole 2!

I can't see it at the author's site. How you know it???

[smity]

The first message on this page. http://radiodom.ucoz.ru/forum/7-27-25 I've already got the prize ... a great thing!

[moscadondres]

How can i get one programmed atmega,thank you.

[smity]

This project does not have a atmega. Here atXmega! Or can be programmed yourself, or contact the author [email protected] .