PIM-2 Digital Metal Detector Project

[Davis9000]

Has someone built pcb v03 with software v05? How does it work?

[eclipse]

I tested AVR programmer with the demo code and atmega328PU and seems there are troubles. Pins look compatible, probably can work as a substitute?
If you can't get the paid version I can send you programmed atmega328

[bernte_one]

no, but i have cotacted lugatek People here in Forum to buy a unlimited µController for pim2 Mustafa version

so if i get one i will finish this Project i hope

[eclipse]

i hope i can follow
[ATTACH]33383[/ATTACH]
[ATTACH]33384[/ATTACH]

Hey have you completed it? Does it performs as expected compared to the regular Delta Pulse?

[sabios]

hello again I'm here and I wonder if there is a version of the hex for pim-2 version 6 Mustafa because as you know with the version 5 of the hex this does not work very well.
I did and really without the hex is just junk, and I sell lugatek scheduled MCU 70 dollars, but ask me in http://www.teknolojiekibi.com and sell the Delta press 3s at 120 dollars, it is clear to arm version but comes with everything up with a coil.

and the truth of 70-120 is very little difference.
I did not think it would cost for both hex pim-2.

to ask them if anyone does not have a version of the hex to use no matter how one test.

and as the partner Saba says: Hi i made this detector, but have a problem, when turn on have sound, after ready detector have tik sound but when metal is detected no detection sound only tik sound, anyone help me.

[eclipse]

Has anyone compared PIM2 vs Delta Pulse 3 or Delta Pulse 3S (must have built those 2). Is the author of these designs the same person (http://www.teknolojiekibi.com/)?
I want to build PIM2 or DP3(s) but still wonder which one to choose.

[saba]

Anyone solve problem with sound?

[bernte_one]

my second child was born in mid of july so i had not much time since then
i will continue my work at end of september

[saba]

Anyone made this pcb, it work?

[saba]

Hi i made this detector, but have a problem, when turn on have sound, after ready detector have tik sound but when metal is detected no detection sound only tik sound, anyone help me.

[Arionas]

Very good your Board my Friend

[bernte_one]

i hope i can follow

[Boadil]

The PCB is over..........we go for the next step[ATTACH]33331[/ATTACH][ATTACH]33332[/ATTACH][ATTACH]33333[/ATTACH][ATTACH]33334[/ATTACH][ATTACH]33335[/ATTACH]

Photo and perfect ... but mounting and the PCB so that it can develop the other fellow?

[Boadil]

What would be the version of hex you are using on this board?

serious hex version 6, but that is not free and you have to pay with it

[RS_Phil]

The PCB is over..........we go for the next step[ATTACH]33331[/ATTACH][ATTACH]33332[/ATTACH][ATTACH]33333[/ATTACH][ATTACH]33334[/ATTACH][ATTACH]33335[/ATTACH]

What would be the version of hex you are using on this board?