Hello. Is it possible to put the PCB here? please .
Thank You
Announcement
Collapse
No announcement yet.
Full m/lab SD2000 schematics
Collapse
X
-
It's not a business secret, read a few pages back, more of them were made by sd 2000! Some with more success, some with less..The whole thing is knowing the scheme, and an acceptable result comes from being as familiar as possible with the setting and operating frequency for which you want to use the sd 2000.Originally posted by ZOUjiarui View PostEverything is a trade secret.
Higher frequency better sensitivity to gold nuggets lower frequency better for relics! I really like the sd 2000 because it has two channels because you can choose between two channels if we want to use a large coil for deep large targets like a large amount of coins and ch 2 which is more suitable for finding individual coins with a smaller coil.
Leave a comment:
-
Hello to all friends and searchers.
Has anyone made sd2000 with acceptable results?
I am waiting for your response.
Thanks
Leave a comment:
-
Stick one of these into it,Originally posted by Jose View PostI read in the forum that the GP3000 series uses an LC oscillator controlled by a varicap diode to vary the frequency, I wonder if it would be possible to adapt it to the SD2000.
Here in my country it is difficult to get crystals of different frequencies to experiment.
Leave a comment:
-
I read in the forum that the GP3000 series uses an LC oscillator controlled by a varicap diode to vary the frequency, I wonder if it would be possible to adapt it to the SD2000.
Here in my country it is difficult to get crystals of different frequencies to experiment.
Leave a comment:
-
You can go lower in frequency but the output Mosfets will need to be upgrades to lower on resistance types.Originally posted by Orbit View Post
Thanks Peter, that means no smaller crystal than 1mhz ..
Leave a comment:
-
It allows the detector to use 1Mhz or lower frequency timebase, beware stretching out the TX below 900Khz as the mosfets will nearly start glowing in the dark.Originally posted by Orbit View Post What would happen if you did not connect that is to 8 pin cd40106 with 100R ?I know it locks Tx, does it affect anything else? Is it possible to take the sample later or earlier after closing the tx signal?
Leave a comment:
-
What would happen if you did not connect that is to 8 pin cd40106 with 100R ?I know it locks Tx, does it affect anything else? Is it possible to take the sample later or earlier after closing the tx signal?
Leave a comment:
-
TLE2022 may not be compatible, it is what is used in the GPX4500/5000 detectors, my bad. I had a re-chipped SD2000 but I sold it and now cannot locate my files.. I made some small sub boards with different chips, but like 8 years ago.
Leave a comment:
-
if you install tle2022, will you probably need to change the amplifier harness?
Leave a comment:
Leave a comment: