Originally posted by h9361
View Post
Announcement
Collapse
No announcement yet.
Threshold Pot doesn't work
Collapse
X
-
You can try it but I doubt this will solve your problem. You have something wrong with your circuit. You should be able to drive an 8-ohm speaker and if you cannot then you probably can't drive a 32-ohm speaker, either.
-
Thank you.Originally posted by surfdetector View PostI made the Hammerhead 1 with the VCO option and had no problems with the circuit as designed. I used 32 ohm headphones.
I have a question about R10. Suppose that i have not connected coil to unit, is it possible to burn R10 or IRF740 if i touch pin-coil of unit?
Leave a comment:
-
I made the Hammerhead 1 with the VCO option and had no problems with the circuit as designed. I used 32 ohm headphones.Originally posted by h9361 View PostDear Surfdetector, since you have tested HH1 with 32R speaker, do you think 32R-0.25Watt can work?
Leave a comment:
-
Dear Surfdetector, since you have tested HH1 with 32R speaker, do you think 32R-0.25Watt can work?Originally posted by surfdetector View Post
Leave a comment:
-
After a lot of trying, i found a 32R-0.25W speaker in my country, is it OK?
Leave a comment:
-
Originally posted by kt315 View Posti can find 50R speaker in chinese e-shop. by two clicks.
32 ohm
Leave a comment:
-
Thanks, do you think 32R can work over HH1? I'm trying to find such speaker.
Leave a comment:
-
you need basic electronics course? nobody here is not academic, we are just beginners.
use a transformer. get a current on the speaker converted from input voltage.
please read the books related electronics more.
Leave a comment:
Leave a comment: