Announcement
Collapse
No announcement yet.
Threshold Pot doesn't work
Collapse
X
-
Did you leave a gap in the shielding? Did you connect the shield to the correct coil end (the one that is connected to ground or supply)?
-
What was the BEFORE shielding waveform look like.
If I see a comparison then maybe I could answer.
Leave a comment:
-
HelloOriginally posted by Carl-NC View PostSorry, I don't know.
Dear Carl
Please forgive me for my questions. According to your advise, i built several coils with shield without any problem.
Now, i start to build a big coil 55cm for my HHD. Before shielding, i checked TP4 form and it was very nice.
But as soon as adding any shield such as foil or graphite, my TP4 form is changed (attached). Do you have any comment for this problem?
Thank you.
Leave a comment:
-
HelloOriginally posted by waltr View PostHard to tell.
Are you just looking to see what the 'sampling delay time' is? Maybe it is the 10usec measurement which is pretty good for a PI.
Maybe better to measure the Control signals. Compare the TX MOSFET gate signal to the Sampling switch signal.
Regardless, the first sample needs to be after the flyback settles. On my HH I have an external delay adjustment which I set between 10 & 25us depending on which coil, ground conditions and desired targets.
Dear Walter
I have a tecknical question about PI concentric coil.
As you know, such coil has two coils inner and outer. My question is that why is tried to use a thinner wire for inner coil?
Do you think wire thickness affect over Delay Timing?
Thanks
Leave a comment:
-
-
Hard to tell.
Are you just looking to see what the 'sampling delay time' is? Maybe it is the 10usec measurement which is pretty good for a PI.
Maybe better to measure the Control signals. Compare the TX MOSFET gate signal to the Sampling switch signal.
Regardless, the first sample needs to be after the flyback settles. On my HH I have an external delay adjustment which I set between 10 & 25us depending on which coil, ground conditions and desired targets.
Leave a comment:
-
-
Yes, looks ok and probably noise in your house.
You need to get it outside and see how it works on real targets.
Remember that the first sample is a few microseconds after TX off. There is always some flyback so the stuff close the TX off will not be sampled.
Leave a comment:
-
-
Yes, I forgot about changing the Damping resistor value.Originally posted by ionut_mtb View Postwhen you connect the shield you need to modify dumping resistor.
What I have done to have multiple coils for the same detector circuit is put a larger value resistor on the PCB.
Than add another resistor one the coils connect that tune the coil to the circuit.
The two resistor are in parallel.
Also, with balanced coils for a PI, both the TX and RX coil have a damping resistor.
Leave a comment:
-
when you connect the shield you need to modify dumping resistor.Originally posted by h9361 View PostHello
Dear Walter
As you know, i have built a concentric coil.
Today, i tried to add a shield (graphite or foil) to both inner and outer coil but i had a problem.
As soon as connecting shield to ground (+B), my TP4 will be broken.
This is TP4 without shield
[ATTACH]58226[/ATTACH]
And this is with shield connection
[ATTACH]58227[/ATTACH]
Do you think it's normal for concentric coil?
Thank you.
Leave a comment:
Leave a comment: