IDX-PRO+VDI

[seadoggy]

sorry, my picture is not correct!! i need more times to make it new!!

oh ok mate no problem.when you finish can send me PM

[Schatztaucher]

[ATTACH]25731[/ATTACH]

sorry, my picture is not correct!! i need more times to make it new!!

[Koala]

Thank you Koala
Did you change anything else in the device or not
Possible scheme created by the device
Ademna some pictures
I will be thankful to you

pictures in post 1520
Highly recommend silverdogs PCB good quality and 100% working. Could have made my own PCB but it's really not worth the effort. Just follow the values printed on the board to make an excellent metal detector. Everything work perfect.

[medj]

Thank you Koala
Did you change anything else in the device or not
Possible scheme created by the device
Ademna some pictures
I will be thankful to you

[Koala]

I want to ask you
What are the spare change it in a
Or not change anything
Do you change the resistors next r7 r8 r25 r26 change the number of laps tx rx

I used these values works good
R7 39
R8 1K8
R25 47
R26 100k

[medj]

I want to ask you
What are the spare change it in a
Or not change anything
Do you change the resistors next r7 r8 r25 r26 change the number of laps tx rx

[Koala]

6.6 ohms is too much for the IDX-PRO TX coil. You will get very low voltage of the TX. The correct value is 1.6 ohms.

My original coil "Classic I SL" measures 3.88 ohms from the end of the cable that includes the resistance of the cable. There may be some variations in coils.

[golfnut]

"i have just finished my silverdog idx and it appares that is not working properly ."


Hard to say,, try all of the usual stuff Do you have plus and minus 4 volts..

Do u have a scope or access to one can u measure thTx coil volts should be about 15v ac


Pos a good pic of your board

S

[Aiko]

the coil ohms are tx 6.6 and rx 39
i cannot tell the exact modal of the coil as i got it from a market its 11 inch with wights sticker on it
threshold has a noticeable change in pp mode.

6.6 ohms is too much for the IDX-PRO TX coil. You will get very low voltage of the TX. The correct value is 1.6 ohms.

[medj]

Possible communicate Emile
*********seadoggy******

[medj]

hi

[seadoggy]

[ATTACH]25731[/ATTACH]

thx alot mate.

[Koala]

97386 is the zip code so not going to help much. On the left lug there should be a number stamped normal very faint. Can get worn off. Maybe if you post a picture someone on here could identify it. Buzzing in PP altered with threshold pot and quite in Disc mode is correct. Just test a working MD and get nearly 4 volts AC across the TX connectors

[gtdavid]

there is 97386 on the sticker.
no i don't have a scope unfortunately.
and i guess you could say buzzing yea.
thanks

[Koala]

the coil ohms are tx 6.6 and rx 39
i cannot tell the exact modal of the coil as i got it from a market its 11 inch with wights sticker on it
threshold has a noticeable change in pp mode.

Is there not a number stamped on the left lug of the coil
Do you have a scope to test the TX and RX are working correctly
Just re read your original post you say beeping in PP do you mean buzzing.