IDX-PRO+VDI

[gaby_sult]

What is the recommended coil and which data coil diameter and induction for IDX?

[gaby_sult]

DD 255x137 template to TGSL but characteristics TX - 0.7CuEm 35 turns - 0,587mH - C = 1uF and RX - 0,2CuEm 265spire - 35,6mH- C 0,033uF. As adjustment VR1 has some effect but not all remove ferrite

[Koala]

Who can help me ? VR1 is minimal and does not remove all ferrite, why and what they can do?

What coil are you using ??

[gaby_sult]

Who can help me ? VR1 is minimal and does not remove all ferrite, why and what they can do?

[manu72]

Thanks Davor.

[Davor]

You may use your PC audio input and a PC oscilloscope program to do that with no cost. You may expect the remaining signal about 1mV at very good balance, and that is what your PC sound card can process.

[manu72]

Hi, i have finished my IDX pro, but I have no oscilloscope to annular coils, i'm thinking of buying one for PC, I wonder if this can be worth http://www.ebay.es/itm/Hantek-6022BE...4AAOSw0HVWAlw2

[mohandes]

hi guru
i have new question and it is:
The received signal at the resonant frequency receiver and only the phase change.please explain
regards

[seadoggy]

Which cable did u used? Does your shield is separated by each other? Thx

USB 2.0 cable,yea it is separated.

[CDI]

yea its work very good i use LM324 instead LF347.

Which cable did u used? Does your shield is separated by each other? Thx

[seadoggy]

Thank's Seadoggy, great job. Did u tested finished md with this board in real soil?

yea its work very good i use LM324 instead LF347.

[CDI]

Here is my IDX pro with pots inside board!!,very good and stable board!!
Enjoy and best Regards

[ATTACH]34660[/ATTACH]

Thank's Seadoggy, great job. Did u tested finished md with this board in real soil?

[seadoggy]

Here is my IDX pro with pots inside board!!,very good and stable board!!
Enjoy and best Regards

[kt315]

Loop Guide.pdf

[calebsone]

sounds easy enough to figure out thanks and I thought this coil would work so im very happy thank you for the help.