IDX-PRO+VDI

[paku]

why i connect the 2 tone board i dont get the 2 tone sound all metal is same sound
im using the silver dog idx pcb and the 2 tone pcb i make from here

[szucs_g]

Many thanx!

[Koala]

Big Thanks Holyuser for this VDI update, works fine
https://www.youtube.com/watch?v=z1GMwVYu66Y

Nice video

have you tried it in the field yet

[reiv]

Big Thanks Holyuser for this VDI update, works fine

https://www.youtube.com/watch?v=z1GMwVYu66Y

[holyuser]

Have You this upgrade for PIC16F690 too?

Yes.

[szucs_g]

Have You this upgrade for PIC16F690 too?

[Koala]

Hy
i have a proplem with my idx board (Silverdog) i use a orginal blue max 950 coil the detektor work but i have no diskrimination i allready try to swap rx tx

proplem is still the same,where i have to look for

thanks compadre

You can check which is the RX with a meter it has a much high resistance. If you get one of the connections the wrong way round you will get a double beep all you just need to swop the RX wires round.

[golfnut]

can you redo with a better pic -- this is taken with good light and focus...

[compadre]

[golfnut]

you need to show us your build so we can see what you did wrong.

Can you remember fitting a 100k in upright config - if not, t you are stuck in PP which is all metal mode.

[compadre]

Hy
i have a proplem with my idx board (Silverdog) i use a orginal blue max 950 coil the detektor work but i have no diskrimination i allready try to swap rx tx

proplem is still the same,where i have to look for

thanks compadre

[paku]

I see now. Did not bother with the VDI. There is a lot of feed back from the tone. Any good beep I dig. Let us know how you get along with the VDI.

i have 3 idx board
but i still not use vdi when i go to dig
i am still use tone
one of my board i make tested for vdi
when i try use vdi going to dig, it get crazy reading on screen then the detection is low

[Koala]

[ATTACH]32270[/ATTACH]

I see now. Did not bother with the VDI. There is a lot of feed back from the tone. Any good beep I dig. Let us know how you get along with the VDI.

[paku]

Post a picture of what you are looking at. Which schematics are you using. The only inductors on the main board are the TX and RX coils

[paku]

Yes, it is inductor and the value is not critical at all. May be 50uH up to 150uH.

ok thanks HolyUser