Originally posted by Carl-NC
View Post
Announcement
Collapse
No announcement yet.
Threshold Pot doesn't work
Collapse
X
-
I don't know exactly how the GPX sounds, but if you want to slow down Q17 try increasing R75 to maybe 100k. You can also add a parallel cap to ground, try different values. A big problem with this is that Q17 is NPN and will tend to turn off quickly due to the high gm-RL gain. An NMOS might behave better.
Also, you are missing the load resistors; R27 and R31 in post 585. Those are critical.
Comment
-
Thanks.Originally posted by Carl-NC View PostI don't know exactly how the GPX sounds, but if you want to slow down Q17 try increasing R75 to maybe 100k. You can also add a parallel cap to ground, try different values. A big problem with this is that Q17 is NPN and will tend to turn off quickly due to the high gm-RL gain. An NMOS might behave better.
Also, you are missing the load resistors; R27 and R31 in post 585. Those are critical.
Please watch the gpx iron rejection,
I added the parallel capacitor and nmos. Please check nmos pins S and D is true?
Do you have any value suggestion for the parallel capacitor?
Last edited by h9361; 10-24-2026, 11:10 AM.
Comment
-
Dear CarlOriginally posted by Carl-NC View PostWhat are you getting, and what do you need? Have you tried changing R & C values? Have you read about RC phase shift circuits?
Do you have any technical information about Magnetar 9000?
Its technology is PI + AMS ( i do not know it).
You can read more the link
https://www.detectorprospector.com/m...tar-9000-r151/
Comment
-
Thanks.Originally posted by Carl-NC View PostIt's a square wave PI, just like the GPZ 7000.
HHD also is square wave, but what difference is there between GPZ and HHD+GB)?
Do you think GPZ uses a high voltage wave?
I had a research about GPZ, i think it uses full H-Bridge.Last edited by h9361; 11-16-2026, 11:10 AM.
Comment
-
HHD is not square wave, it has a classic exponential turn-on. Square wave PI (also called constant-current PI, or CCPI) turns on the coil with a constant current:
This requires a high voltage at turn-on. Yes, it uses a full H-bridge. This has been discussed a lot in the forums, here is one of those threads:
Comment
-
Thanks,Originally posted by Carl-NC View PostHHD is not square wave, it has a classic exponential turn-on. Square wave PI (also called constant-current PI, or CCPI) turns on the coil with a constant current:
This requires a high voltage at turn-on. Yes, it uses a full H-bridge. This has been discussed a lot in the forums, here is one of those threads:
https://www.geotech1.com/forums/foru...ve-to-h-bridge
so, your Bipolar version is a square wave?
Comment
Comment