felezjoo PI(the best pulse induction metal detector that I made until now)

[gandolfi]

thank you a lot marty. i will test it

[MartyJ1963]

@ Gandolfi,,,,This is a working pcb,,,If you load it into Sprint Layout you will be able to export the Gerber files from it. Marty

[gandolfi]

hi,
My detector is dead....

Anyone have GERBER file for the PCB ?

thanks

[basellafe]

meybe its a weak from short secret and burned with a high pulse more than 200 or meybe bad connection coil cable and suddenly dissconnected or from touch hand many thing

[Kostasp]

Thanks I will buy new what you thing 840 is burned?

[basellafe]

change 840and bs 170

[Kostasp]

what burn again

work good for some time and then start coil error change lf357n the same error what burn this time.

[Engr Obaid]

felezjoo PI(the best pulse induction metal detector copied from the russian site , just visit the and made a unlimited HEX free detector


https://acdc.foxylab.com/node/47

[Kostasp]

check this point and connection between bs and atmega

thanks basellafe thats the error now its ok with coil 28,5 cm 1,4ohm 370uh very strong

[Engr Obaid]

Dear All , Any update regarding full working HEX , Owner of this detector didn't respond , with out full HEX project is incomplete

[basellafe]

check this point and connection between bs and atmega

[Arionas]

Qiaozhi

ok thanxs

[Kostasp]

Yes in resistor I have 9.50 but I change two ic and i have the same error

[basellafe]

if you have 9.50v on this resister its mean ok 18k just change ic with another brandand press down should this msg gone

[Qiaozhi]

FelezJoo_PI_v3_35

Arionas - I have deleted the huge amount of text you attached to your post, as it was seriously slowing down the forum.
If you want to attach hex code, then compress it as zip and attach it as you would any other file.