If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I share the link on the archive and you get my email address. somebody evil intruder did harm me and subscribed on VIOLITY spam messages.
LOOK - this is NOT my phone number, i am NOT living in Ukraina. what going with YOU there??? you answer me by mud on my good!
I see LF356 bought from Lemona (electronics shop) is not so fast I waited. even buying in shop you are not be guaranteed. so the pcb will send AS-IS. I have not possibilities and time to sort through them.
anyway you can change the op amp on yours in anytime.
Hello! Sorry for the stupid question (I haven't made PI for a long time). Where is the correct place for the damping resistor? DELTA PULSE device. Thank you!
better inside a coil. but for tuning you can not open clued coil. in DP the damping resistor sets on the PCB. also, you do not need to tune the resistor as DP is working
with 40us FIRST DELAY.
Hello, My device is delta pulse 2 was working fine.... Today, I tried to turn it on and found it only works in manual tune.
In automatic mode, when I press the reset button, the sound disappears for a few seconds and then returns.
Can someone help me?
Comment