Delta Pulse

anyone know this software please help me

Hi all
i want to ask ,can i use this software ( Virtins Sound Card Instrument Manual ) instead real Oscilloscope?
i think that this software does not work more voltage (Signal with high voltage can easily burn your sound card or even your computer)
is it delta pulse tr0 tr1 ... and pins TLF356 more voltage? if "yes" can i decrease voltage by resistor then measure them?
anyone know the software is useful please tell me.(i have one laptop pc).
Thanks alot for reply.

help for build coil.

Hi all
i live in small city.
i can not find wire 1mm . it is here 0.9mm (AWG 19).
i want to build 1*1m coil and 60*60.
turn 1*1m = ?
turn 60*60=?
and i should use shield or no.
thanks.

[aft_72005]

Hi 786
1N 4148 is DUS diode or it is popular.
Shotky diode specification and characteristic had many different with 1N4148.
In switching applications we cannot use DUS diode instead of shotky diode.
But if you use IN4148 for timing section at pin 14, 4538 IC in xr-71. yes,
You be able use it.

i want to use on XR71

Hi
aft_72005
can i use on XR71 TOO?
THANKS A LOT FOR REPLY.

[aft_72005]

Hi all
i can not find the D(BAT46)
i want to change D(BAT 49) .CAN I CHANGE WITH (BAT43 OR BAT42)?
can you help me for this problem?
regards!

Hi 786
If your opinion using this schotky diodes for deltapulse , you can
Use instead of it, 1N4148.
Regards.

i have ?

Hi all
i can not find the D(BAT46)
i want to change D(BAT 49) .CAN I CHANGE WITH (BAT43 OR BAT42)?
can you help me for this problem?
regards!

[strujas]

Doesn't matter... 17 turns is ok.

Thanx

[1843]

Which thicknes of wire 1mm?
how much windings for 0.8mm?

Doesn't matter... 17 turns is ok.

[strujas]

Hi,

17 Turns is for 1m x 1m.

regards!

Which thicknes of wire 1mm?
how much windings for 0.8mm?

[1843]

Hi,

17 Turns is for 1m x 1m.

regards!

[strujas]

I haven't been enough precise, i am planing to construct square coil 1x1M, I supose that your friend had made round coil, square coil have bigger surface, and i supose that i need to wind less windings for square coil, 1 or 2 less, what you think?
Regards!

[Geo]

Thanx Geo, I will make that soon!

Ok.
A friend tried it before 2 weeks with very good results.

[strujas]

Thanx Geo, I will make that soon!

[Fred]

Hi,
I have just started my DP, and it looks, that everything is working well
Tommorow I'll buy missing LF357 and 555, but it can take me few days until I'll get AWG wire to make the coil.
Photo of my DP, and photo of scope showing signals TR3 and TR5.

Hi Pektro,

You have soldered all potenciometers on the copper side of the PCB, so all controls will be reversed, did you do this on purpose?

Regards,
Fred.

[Geo]

Hi guys, Did any of you tryed to make coil for DP diameter 1M (100cm)?

17 turns with wire 1mm is OK
Good luck