Delta Pulse

[Freddy67]

As I can not open the file .. lay,


all u need in link http://www.sonsivri.to/forum/index.php?topic=8502.0
j.

Thank you Jap but the link no longer works http://rapidshare.com/files/78012726/layout50.rar.html.

[jap]

Hi Nikolov
Where you applied the coil specification true,the difference here cable production difference(quality of cable)
its,,,,OK.
best time
j.

[Nikolov]

Hi Jap for 32cm coil you said 4.6R in my coil is 5.4R it is OK?

[jap]

As I can not open the file .. lay,

Hi Freddy67
all u need in link http://www.sonsivri.to/forum/index.php?topic=8502.0
best time
j.

[jap]

Hi Nikolov
good test,if Freq is 130Hz on NE556 pin9 its good for deep(DP is deeper).let all in place
--Try CAN Cola Iron And see the difference.
best time
j.

[Nikolov]

OK, I finished the 32cm coil, 1L alu can detect on 65cm . Resistance is 5.4R. With this resistance what to change R5 or R6 or.....

BUT I found some "mistakes" on board. In my board PR is 250K instead 200K and for 250K PR -R1 will be 680K or 470K

Freq is 130Hz on NE556 pin9

Regards

[Freddy67]

Hi Jap
It depends if the circuit is irradiated, if we use the method of iron or if you draw by hand. It is better to have the two versions.

Regards

[jap]

Hi Freddy67
THE First will be used directly for printing and does not need to be reversed
This importance,,,,
best time
j.

[pigeon]

Hi pigeon
a schematic that U need it .
best time
j.

thank you

best time

[pigeon]

hello, its are absent at the Turkish PCB.


yours

thank you

best time

[Freddy67]

Hi and thank you very much Jap.
It was to be sure.
Enclosed the circuit Jpg. As I can not open the file .. lay, I am amused to remove all the components and redraw the circuit in black with Paint .

And reverse

[jap]

Hi Freddy67
Yes,,,two are OK
best time
j.

[Freddy67]

Hello to all

What are the two straps? According to the diagram, they are connected to the + and - E. Is this correct?
All photos there is no visible connection.

With my thanks and greetings.

[kt315]

hi

please where's the emplacement for r50and r51 in the pcb

thank you best regards

p.

hello, its are absent at the Turkish PCB.


yours

[jap]

Hi pigeon
a schematic that U need it .
best time
j.